Your cart
There are no more items in your cart
How to change the clutch of my TM Racing 250/300Fi ?
Is the engine of your TM Racing 250 / 300Fi starting to show signs of weakness? You clutch begin to be a bit slippery ? It is surely time to change the discs and springs of your tm engine.
In normal use, it is usual to change its clutch every 50 Hours, if you are hard on yours, you can surely check at 35 Hours.
This operation is simple and does not require any specific tooling.
This tutorial fit the following MY :
TM Racing 250Fi 4S EN/MX/SMX 2010-2020 TM Racing 300Fi 4S EN/MX/SMX 2017-2020
1 - Drain the engine oil as described in the relative paragraph. Unscrew the M5-L65 (1) and M5-L25 (2) screws, then remove the clutch cover (3).
2 - Remove the gasket (4).
3 - Unscrew the screws (5) of the clutch pack.
4 - Remove the spring (6) and the pressure plate (7)
5 - Remove the discs (8).
6 - On re-mounting the new discs, lubricate them with engine oil and make sure that the first disc mounted is lined, and that the first two smooth discs have thickness of 1.8 mm (the other discs have thickness of 1.5 mm).
7 - Remount the pressure plate (7) with the relative springs (6).
7 - Re-mount the screws (5) and tighten them crosswise and gradually with a torque of 8 Nm (0.8 kgm/ 5.9 ft/lb).
8 - Check that the gasket (4) is not ruined, otherwise replace it.
9 - Mount the clutch guard (3) and tighten the screws (1) M5-L65 and (2) M5- L25 gradually with a torque of 8 Nm (0.8 kgm/ 5.9 ft/lb)
Introduce VROOAM VR90 10W50 oil into the engine oil as described in the relative tutorial
Clutch plate and parts TM Racing 250/300Fi 2010/2020
- (15) : 1,5mm steel plate x5
- (14) : 1,8mm steel plate x2
- (13) : Clutch plate, Fiber x8
- Clutch Spring x6
- Clutch cover gasket x1
Find our others tutorial :
It's never been easier to check and adjust the valves on a tm 4-stroke motorcycle engine.
read more
The tm motorcycles are equipped since 2008 (option until 2014) with a Kayaba 48mm fork, maintaining your fork by replacing the oil is an operation that must be done at least once a year, and ideally every 20 hours of riding.
read more
A maintenance ? Some air on the system, a reset is probably necessary on the oil injection system.
read more
The TM Racing valve system works with a servo motor, so after any maintenance, do not forget to reset it.
read more